WCH32 (with blend)

Housing WCH32 is developed especially for use in industrial companies under hot shop conditions. Supply set includes the pneumatic blend worked out in order to prevent the observation glass from pollution by creating an air barrier in front of the glass that doesn’t let dust and dirt accumulate. Any modification of WCH32 housing may be completed by additional defense pneumatic blend. The blend also promotes heat removal from the observation glass.
Made out of stainless steel 12X18H10T (AISI 321Ti).
Maximum environmental temperature: +200°C (toughened glass).
Class of protection from environmental effects: IP66.

Function
Features
Environmental parameters
Geometrical parameters
Constructive parameters
Electrical parameters
Additional information
{reg} {reg}Similar models

Function

Housing WCH32 is developed especially for use in industrial companies under hot shop conditions.
Supply set includes the pneumatic blend worked out in order to prevent the observation glass from pollution by creating an air barrier in front of the glass that doesn’t let dust and dirt accumulate. Any modification of WCH32 housing may be completed by additional defense pneumatic blend. The blend also promotes heat removal from the observation glass.

Operating Principal

A regulated flow of cold water enters through a lower connecting pipe. By flowing through the interior cavity, the water cools the housing and the equipment installed within it. The heated water goes out through an upper connecting pipe, which ensures guaranteed filling-up of the entire cavity.
Regulation of the flow of cooling liquid can be done in two ways:

• manually, with the choke washer (the orifice section is calculated according to the reference table)
• manually, using the relief valve

There is an emergency switch which turns off all the housing’s electrical equipment when it reaches a critical temperature. At the same time this is the housing’s emergency indicator.

Features

1. Developed specifically for use by industrial companies in hot shop conditions
2. Completed with defense pneumatic blend worked out in order to prevent the observation glass from pollution and to remove heat from the glass
3. Made out of stainless steel 12X18H10T (AISI 321Ti)
4. Maximum environmental temperature: +200°C (toughened glass)
5. Class of protection from environmental effects: IP66
6. Input voltage: 220V AC or 24V AC (shall be selected by user)
7. Power consumption: no more than 14W
8. Built-in camera power supply with standard supply voltage range (24V AC/400mA; 12 DC/400mA; 9 DC/400mA), galvanic power supply decoupling
9. Emergency circuit breaker (the power supply switches off when the temperature inside the housing rises to critical)
10. Includes wall bracket made from stainless steel 12X18H10T (AISI 321Ti)
11. Two nickel-brass watertight cable glands for two cables of between 6 and 10 mm diameter

Environmental parameters

Geometrical parameters

Overall dimensions and usable volume:

Constructive parameters

Technical characteristics of defense pneumatic blend

• inlet fitting for compressed air supply - 1/2"
• air expenditure under pressure
  • 1 BAR - 1,38 l/s
  • 1,5 BAR - 2,07 l/s
  • 2 BAR - 2,75 l/s
  • 2,5 BAR - 3,44 l/s
• dimensions - Ø130х30 mm
• made of 12Х18Н10 stainless steel

Electrical parameters

Additional information

Supply set:

{reg} {reg}Similar models

WCH32